Crank Cam Position Sensor Connector Plug Terminal for LS1 LSx Engine 2pcs

  • $10.99
  • Item Code: CON-LS-CAMCN-7031Y1821X2
  • Availability: In Stock
Qty:  

Crank or Cam Position Sensor Connector Wiring Plug Assembly Kit with Terminals for GM Gen III LSx Engines (LS1/LS6/LQ4, and early LS2) with a 24x (24 tooth) Crankshaft Reluctor Wheel.

Note: NOT for Gen IV LS Engine (LS3/LS7/LS9, and later LS2) with 58x Tooth Crankshaft Reluctor Wheel.

Sold As Two-Pieces Kit

Note: Pigtail Wire Shown On Pictures Are Not Included

 

Write a review

Note: HTML is not translated!
    Bad           Good
Captcha


Emissions Control Warning:

It is illegal to sell, install, or offer for sale any aftermarket part that alters or modifies the original design or performance of the motor vehicle pollution control system. Product(s) listed here is(are) solely for Competition Vehicles(race vehicles) that are for Off-Road, Track Racing ONLY. All parts are for use on a vehicle that will NEVER be used, or licensed, or registered for use upon a street and highway. DO NOT Purchase the part(s) if you are intending to use it(them) on a Street/Highway vehicle(s).

All Products by B1SPEED are solely for Competition Vehicles(race vehicles) that are for Off-Road, Track Racing ONLY. All parts are for used on a vehicle that will NEVER be used, or licensed, or registered for use upon a street and highway. DO NOT Purchase the part(s) if you are intending to use it(them) on a Street/Highway vehicle(s).
Proposition 65 Warning:

These products may contain chemicals known to the State of California to cause birth defects or other reproductive harm. For more information visit www.P65Warnings.ca.gov.


Copyright © 2021 - B1Speed.com - All rights reserved