Crank Sensor for Gen IV LSx Engines LS3/LS7/LS9 later LS2 58x Tooth Crankshaft Reluctor Wheel

  • $28.17
  • Item Code: SEN-LS-CRANK-58T
  • Availability: In Stock
Qty:  

Crank Sensor for GM Gen IV LSx Engines(LS3/LS7/LS9, and later LS2) with 58x Tooth Crankshaft Reluctor Wheel.

Note: NOT for Gen III Engines (LS1/LS6/LQ4, and early LS2) with a 24x (24 tooth) Reluctor Wheel.

What's in the box?
This is for One Piece of Crank Sensor ONLY, All Other Parts Shown Are NOT INCLUDED.

PRODUCT(S):
Sensor x1

Installed Photo:



 

Write a review

Note: HTML is not translated!
    Bad           Good
Captcha


Emissions Control Warning:

It is illegal to sell, install, or offer for sale any aftermarket part that alters or modifies the original design or performance of the motor vehicle pollution control system. Product(s) listed here is(are) solely for Competition Vehicles(race vehicles) that are for Off-Road, Track Racing ONLY. All parts are for use on a vehicle that will NEVER be used, or licensed, or registered for use upon a street and highway. DO NOT Purchase the part(s) if you are intending to use it(them) on a Street/Highway vehicle(s).

All Products by B1SPEED are solely for Competition Vehicles(race vehicles) that are for Off-Road, Track Racing ONLY. All parts are for used on a vehicle that will NEVER be used, or licensed, or registered for use upon a street and highway. DO NOT Purchase the part(s) if you are intending to use it(them) on a Street/Highway vehicle(s).
Proposition 65 Warning:

These products may contain chemicals known to the State of California to cause birth defects or other reproductive harm. For more information visit www.P65Warnings.ca.gov.


Copyright © 2021 - B1Speed.com - All rights reserved