Titanium Stud Kit For 13B Race Application

  • $587.00
  • Item Code: STUD-KIT-RACE-13B-TI
  • Availability: In Stock
Qty:  

0 reviews / Write a review

Titanium stud kit for Race application.
Fits 13B rotary engines from 72-95.
(12 studs)10.5mm diameter combined with(6 studs)12.5mm with stock thread , Titanium nuts and washers included. Total of 18 studs in Race kit.
Supports higher boost applications for street and race.
Drilling Required for 12.5mm studs (3/4 of engine)
No drilling required on front primary plate(threaded plate)
Half the weight of conventional steel, strong tensile strength.

BeBelow Are Installation Pictures:

Write a review

Note: HTML is not translated!
    Bad           Good
Captcha


Emissions Control Warning:

It is illegal to sell, install, or offer for sale any aftermarket part that alters or modifies the original design or performance of the motor vehicle pollution control system. Product(s) listed here is(are) solely for Competition Vehicles(race vehicles) that are for Off-Road, Track Racing ONLY. All parts are for use on a vehicle that will NEVER be used, or licensed, or registered for use upon a street and highway. DO NOT Purchase the part(s) if you are intending to use it(them) on a Street/Highway vehicle(s).

All Products by B1SPEED are solely for Competition Vehicles(race vehicles) that are for Off-Road, Track Racing ONLY. All parts are for used on a vehicle that will NEVER be used, or licensed, or registered for use upon a street and highway. DO NOT Purchase the part(s) if you are intending to use it(them) on a Street/Highway vehicle(s).
Proposition 65 Warning:

These products may contain chemicals known to the State of California to cause birth defects or other reproductive harm. For more information visit www.P65Warnings.ca.gov.


Copyright © 2021 - B1Speed.com - All rights reserved