Head Stud for LS/LM/LQ Engine LS1 LS3 LQ9 5.3L 5.7L 6.0L Short Length

  • $11.64
  • Item Code: BOLT-L1-S
  • Availability: In Stock
Qty:  

CXRacing 1 Piece of Chromoly Cylinder Head Stud for 1996+ All GM/Chevy LS/LM/LQ Engines

Fits LS1, LS2, LS3, LS6, LS7, LQ4, LQ9. LM4, LM7, 4.8L, 5.3L, 5.7L, 6.0L, 6.2L, 7.0L

This Item is ONLY for One Stud, It is the Short Stud (M8, 64mm Length)

Features:

- 200,000 PSI Strength
- 12 Point Nuts, with Washers
- Black Oxide Finish
- M8 x 64mm Stud

These Cylinder Head Studs Are Made With High Quality Chromoly Steel, Hold Extreme Strength for High Power Engine Builts, Such As Boosted Applications.

Recommended Torque Spec: 22 lb/ft

Item(s) Included:
- Short M8 Stud x1
- Nut and Washer x1

Installed Picture(s):




















Write a review

Note: HTML is not translated!
    Bad           Good
Captcha


Emissions Control Warning:

It is illegal to sell, install, or offer for sale any aftermarket part that alters or modifies the original design or performance of the motor vehicle pollution control system. Product(s) listed here is(are) solely for Competition Vehicles(race vehicles) that are for Off-Road, Track Racing ONLY. All parts are for use on a vehicle that will NEVER be used, or licensed, or registered for use upon a street and highway. DO NOT Purchase the part(s) if you are intending to use it(them) on a Street/Highway vehicle(s).

All Products by B1SPEED are solely for Competition Vehicles(race vehicles) that are for Off-Road, Track Racing ONLY. All parts are for used on a vehicle that will NEVER be used, or licensed, or registered for use upon a street and highway. DO NOT Purchase the part(s) if you are intending to use it(them) on a Street/Highway vehicle(s).
Proposition 65 Warning:

These products may contain chemicals known to the State of California to cause birth defects or other reproductive harm. For more information visit www.P65Warnings.ca.gov.


Copyright © 2021 - B1Speed.com - All rights reserved